I’ve spent a lot of time over the past few weeks doing nail art tutorials for people to try out and I’ve learnt a lot about how to make them.
I’m pretty good at nail art, but this is the first time I’ve made my own nail polishes, so it’s not the easiest way to make something new.
In this tutorial, I’m going to show you how to get started making nail polish in a few easy steps, and it’ll be pretty easy to follow too.
First, you’ll need to make a little tutorial on how to cut a square of acrylic and nail it onto the base of a nail.
Then you’ll want to take your nail polish base and paint a round of nail polish on it.
You’ll want your base to have a hole at the centre, so you can poke a small hole in the base, and then you can make your hole with your fingers, as I did in the video above.
Then, you can use a piece of paper to cut your nail to the shape of your cut-out.
You can also make your cut on a flat surface, but I’m using the nail to cut it into a round shape.
Next, you’re going to want to paint your base and then apply the nail polish.
You should be able to see the nail on the base.
I didn’t want to make the nail too thick, so I made a small dot of nail-paint on the top of the nail and a little bit of paint in the middle.
Then I sprayed a thin layer of nail paint onto the top and bottom of the base and I let the nail paint dry for a while, and when I came back I found the nail had dried to a very fine level.
Finally, apply the top coat to your nail.
The nail should look like this when dry, and once the polish is dry, it should still look like a little square of polish.
After you’ve applied your top coat, you need to apply the bottom coat.
I just put a thin coat of nail wax on the nail, then just sprayed some nail polish over it.
Now you need your base.
You want to start by placing your nail on top of a piece.
I found that my base is easy to reach by putting the tip of my finger into the hole, and that makes the nail easier to reach.
Then push the nail into the base like this.
Once the nail is in, you will need to cut off a bit of the top.
If you’re not very careful, you could end up with your nail poking through the base into the middle of your nail and creating a big hole.
Then, you are going to apply your second coat of top coat.
The first coat is just a thin coating of nail varnish, then you will want to apply a layer of topcoat to the topcoat.
You will want a layer that’s about the same thickness as your base, so that you can slide your nail through easily without a lot more effort.
Once you’ve done that, apply your third coat of the second coat, and finally, you want to add a little more topcoat, but leave it on a very thin layer.
Once your nail is dry enough to slide through, you have to apply one more coat of polish, but don’t worry, you don’t have to put any more on.
Lastly, you do have to make sure that your nail will adhere to the base perfectly.
You will want it to be as smooth as possible, and the nail should be as straight as possible.
I used a very thick nail polish, and I made sure that it stuck very well to the nail.
This tutorial can be a little confusing, so if you’ve never made nail art before, you might want to give it a try.
I hope you enjoyed this tutorial and it helped you make your very own nail art.
I’ll see you next time!